I looked up the towing capacity of a 2007 Chevy Silverado 2500 with a 6.0 and every configuration was well over 7,600 lb so yes it could. Looks like lowest configuration is 9,600 lb towing capacity and highest 13,000 lb. I'd recommend confirming this with your owners manual or local GM dealer though.
If you were looking for a fifth wheel hitch the Curt A20 part # C16140 would be a great option. It has more than enough weight capacity and also has a really tight jaw design that which provides... view full answer...
For your 2007 Chevy 2500 with 6.5 foot bed, if you want to use your current rails, you will need some new hardware as it is not wise to use old hardware on these 5th wheel rails. I recommend the Replacement Hardware for Curt Universal 5th Wheel Installation Kit - 10 Bolt # C16111.
If you want new custom rails for your truck for an easier install an no drilling into your frame, you will want the Reese Quick-Install Custom Base Rails and Installation Kit for 5th Wheel Trailer Hitches... view full answer...
As long as the circuit you plan to use the part # BX88727 is less than 20 amps, you could use this fuse bypass switch on your 2007 Chevy Silverado. view full answer...
The drop from the top of the frame bracket of the hitch # BWHDRH25187 to the top of the receiver is approximately 5.65”. From the end of the receiver back to the flat portion of the bar is approximately 6.5”. From the end of the receiver back to the first set of frame bolt holes is approximately 12.18”. view full answer...
The Reese M5 5th Wheel Hitch part # RP30928 can be used on a 2007 Chevrolet Silverado 2500 but you need to use the Reese Quick-Install Custom Installation Kit w/ Base Rails for 5th Wheel Trailer Hitches part # RP50064-58. Don't forget the Curt 5th Wheel/Gooseneck Wiring Harness 7-Pole part # C56000. view full answer...
Yes we have the Air Lift LoadLifter 5000 kit part # AL88275 as a fit for your 2007 Chevy Silverado 2500HD Classic that is compatible with in-bed hitches like the B and W hitch # BWGNRK1067 that you have. view full answer...
Since your 2007 Chevy Silverado 3500HD is a cab and chassis model the Curt Trailer Hitch Receiver # 13028 will fit it without any modification. This hitch is designed to fit the narrower 34 inch wide frame your truck has. view full answer...
What you'll want is the adapter kit part # 41157. This plugs inline with the 7-way at the rear of your 2007 Chevy Silverado and gives you an additional 7-way you can mount up in the truck bed for your camper. view full answer...
The Brophy camper tie-downs # HSAB will fit your 2007 Chevy Silverado Classic 1500HD and work well. We also recommend hardware package # TDHP. I have linked a video review for you. view full answer...
If your 2014 Arctic Fox 25-W has the large ramp door in the back (like a toy hauler) then Adco cover # 290-34874 is a great option for wind and UV protection. It also comes with tire covers which is great since sun can harm tires especially in intense sunlight like you would get in Arizona. there are openings for access at the vey back and along the side.
The covers we have are off-the-shelf options. We do not have an option for a custom cover. view full answer...
When I looked up the online version of the owner's manual for your 2007 Chevy Silverado 1500 Crew Cab it looked like the least rated option was still 6,700 lbs and that is if you have the 3.23 axle ratio. If you look at the online owner's manual (can be found a variety of ways) then you can pin point your weight rating.
It could be that the trailer hitch included with your tow package it only rated for 5,000 lbs towing/500 lb tongue weight but that is something you can find on the trailer... view full answer...
The backup camera kit by Rearview Safety part # RVS-776614-213 that you referenced can be wired so that it can be turned on with a switch to view behind you at all times or just when in reverse. The circuit that activates the system normally wires to the reverse light circuit which tells it to come on when in reverse. Some people will wire the setup to the running light circuit instead so that they can see behind them with that circuit or with just a switch to a 12 volt power circuit active... view full answer...
Timbren does offer a fit for your truck, part # TGMRTT35S but I'd recommend going with the SumoSprings
# SSR-201-47-2 instead. The Timbren model is more designed for severe service vehicles like tow trucks, and wouldn't give you the ride quality you're looking for. The SumoSprings would offer 4600 lbs of additional support without ruining your ride quality. The kit is compatible with DRW vehicles. The springs sit inboard of the leaf spring packs, so they won't interfere with your existing... view full answer...
You have two options for 5th wheel towing with a short-bed truck such as your 2007 Chevrolet Silverado 2500 Diesel 4X4 with 6-1/2-foot box. A sliding 5th wheel hitch is one way to get around the limited trailer-to-cab clearance with such short-bed trucks and the other is to use a Sidewinder replacement pin box on the 5th wheel. Both of these products, which cannot be used together, provide additional turning clearance for low-speed maneuvering.
There are several types of 5th wheel installation... view full answer...
The Husky Silver Series 26K W 5th Wheel Trailer Hitch # HT31318-31325 will install simply in the same fifth wheel rails that your 16k hitch installed into in the bed of your truck.
This hitch also uses the same head design as the 16k hitch so the coupling process will be the exact same.
The hitch comes in three pieces. There will be the legs of the hitch, the crossmember, and then the head. view full answer...
There are actually several different bolt patterns for a Mercedes-Benz Sprinter Van. If you have the larger 6 on 205 mm bolt pattern which can be found on the 3500 models then the Front Mounted Trailer Hitch Universal Spare Tire Carrier part # 6715 cannot be used because the slots will not span the distance between the lug nut holes it needs to attach to on your wheel. However, we do still have an option for you in the Roadmaster Hitch Mounted Spare Tire Carrier part # RM-195225 which is... view full answer...
The correct Curt fifth wheel brackets for your 2007 Chevy Silverado 2500HD new body style are the part # C16418. These are the brackets of the rail kit part # C16418-204 which fits your truck and as long as you have the Curt fifth wheel rails you'd be set. view full answer...
There will be two options for adding a plow to the front of your 2007 Chevy Silverado Classic. Keep in mind that both of these options will be for the 1500 LD model of Silverado, but with that being said, let's get into it.
The First way to go about adding a plow will be using a front mount hitch, like the Curt # 31302. This allows the Detail K2 Elite Snowplow # K2AVAL8422ELT to attach to your truck without the need of custom brackets.
The other option is the Custom Mounting Brackets... view full answer...
Installing a fifth wheel hitch in the bed of a truck that has a flat bed with a recessed ball can be challenging but for a simpler solution I would use a Convert a Ball Fifth Wheel to Gooseneck Adapter part # CAB-C5G which would attach to your king pin plate and give it a gooseneck coupler for your gooseneck ball to attach to. view full answer...
Yes, the fifth wheel rail install kit part # RP50064-58 that you referenced has been confirmed as a fit for your 2007 Chevy Silverado 1500 so it would work well for you.
The included rails of this kit are compatible with some RBW hitches (like the lil rocker) so it could work well with your hitch too. You would need to compare the rails to the ones in the picture I attached.
I attached an install video for this rail kit for you to check out as well. view full answer...